Previous Jobs Window - SICE A 92 Manual De Instrucciones

- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 (or "Enter") goes to the next window
- F4 sets the units of measurement:
Toe angle

o Degrees;
o Length;
Setback and Track Difference

o Degrees
o Length
Length

o Millimetres
o Inches
Angles

o Centesimal degrees
o Sexagesimal degrees
Pressure

o Bar
o Psi
Weight

o Kilograms
o Pounds
- F10 returns to the starting window.
The window can be called up from different parts of the program by pressing the F8 key,
selecting the "Previous Jobs" option from the list and pressing the F3 key.
If the job record (at least the registration number) has been filled in for the vehicle being
measured, when this function is accessed the program displays the list of jobs already saved for
the vehicle; otherwise, it displays the full list of all the jobs on record, to allow selection of the
job required.
After selecting the memorised job for display, press F3 and the screen will display all the values
saved and the values currently measured, to allow easy comparison, so any shifts in the
vehicle's geometry can be identified at a glance.
The following keys are active in the job record selection screen:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 (or "Enter") goes to the next window
- F4 to print the list of jobs on record
- F10 goes back to the previous window.
The following keys are active in the screen which compares with saved and current values:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F7 prints the comparison between the saved and current values.
- F10 goes back to the previous window.

PREVIOUS JOBS WINDOW

80