Balluff BMD 1H Serie Manual De Instrucciones página 111

Setup - Min. adjustment
Level
Setup - Max. adjustment -
Interface
Enter the appropriate distance value in m (corresponding to the
percentage value) for the full vessel. The distance refers to the sensor
the max. level must lie below the dead band.
In this menu item you can enter the min. adjustment for the level. With
interface measurement this is the minimum total level.
Adjust the requested percentage value with [+] and store with [OK].
Enter the suitable distance value in m for the empty vessel (e.g.
centage value. The distance refers tot he sensor reference plane (seal
This menu item is only available if you have selected interface meas-
urement under the menu item "Application".
Enter the requested percentage value for the max. adjustment.
Enter the respective distance value in m for the surface of the upper
medium corresponding to the percentage value.
6 Set up with the display and adjustment module
-
29