Balluff BMD 1H Serie Manual De Instrucciones página 97

Welding work
In owing medium
Measuring range
1
1 Unfavourable mounting
Before beginning the welding work, remove the electronics module
from the sensor. By doing this, you avoid damage to the electronics
through inductive coupling.
The reference plane for the measuring range of the sensors is the
Keep in mind that a min. distance must be maintained below the refer-
ence plane and possibly also at the end of the probe - measurement
in these areas is not possible (dead band). The length of the cable
can be used all the way to the end only when measuring conductive
4 Mounting
2
15