Sleep Timer [Sleep]; Adjusting The Output Level Of The Subwoofer And Center/ Surround Speakers [S.wfr, Center, L-Surr.-R]; Adjusting The Treble Sound [Treble]; Changing The Scan Mode - JVC TH-S3 Manual De Instrucciones

Basic operations

Sleep Timer [SLEEP]

The system turns off automatically when the specified period of
time has passed.
Press SLEEP.
Each time you press the button, the shut-off time changes.
Example:
S L E E P 6 0 m i n
To check the remaining time
Press SLEEP once.
To change the remaining time
Press SLEEP repeatedly.
To cancel
Press SLEEP repeatedly until "SLEEP OFF" appears.
• Turning off the power also cancels the Sleep Timer.
Adjusting the output level
of the subwoofer and
center/surround speakers
[S.WFR, CENTER,
L-SURR.-R]
Press S.WFR +/– to adjust the subwoofer.
Press CENTER +/– to adjust the center
speaker.
Press SURR.-L +/– to adjust the surround
left speaker.
Press SURR.-R +/– to adjust the surround
right speaker.
NOTE
• You can also make adjustments by using the setup menu shown on the
TV screen. (See page 32.)
• The adjustments take effect for all sources.
• You cannot make this adjustment when FM or AM is selected as the
source.
Adjusting the treble
sound [TREBLE]
Press TREBLE +/–.
NOTE
• The adjustments take effect for all sources.
15
minutes

Changing the scan mode

The system can be accommodated to your TV's scan mode.
• To use the system in progressive mode, it is required that the
center unit is connected to the TV using a component video cord
(not supplied) in advance. (See page 9.)
7 While DVD is selected as the source and before playback
1
Press and hold SCAN MODE for
2 seconds.
The current setting appears on the display window.
2
Press Cursor 3/2 to select the desired
mode.
• PAL: Select when your TV supports the PAL
interlaced video input only.
• PAL PROG.: Select when your TV equipped with
component jacks supports the PAL
progressive video input.
• NTSC: Select when your TV supports the NTSC
interlaced video input only.
• NTSC PROG.: Select when your TV equipped with
component jacks supports the NTSC
progressive video input.
You can get better picture quality in "PAL PROG." or "NTSC
PROG." mode than in "PAL" or "NTSC" mode.
3
Press ENTER while the selected mode
is shown on the display window.
When "PAL PROG." or "NTSC PROG." is selected, the
PROGRESSIVE indicator lights on the display window.
NOTE
• Although the picture may be distorted when you press ENTER, this
is not a malfunction of the system.
• There are some progressive TVs and High-Definition TVs that are
not fully compatible with this system, resulting in an unnatural
picture when playing back a DVD VIDEO in the progressive scan
mode. In such a case, change the scan mode to
To check the compatibility of your TV, contact your local JVC
customer service center.
• All JVC progressive TVs and High-Definition TVs are fully
compatible with this system.
See page 13 for button locations.
"PAL" or "NTSC."