Av Compu Link Remote Control System; Connection And Setup - JVC TH-S3 Manual De Instrucciones

AV COMPU LINK remote control system

The JVC AV COMPU LINK system allows you to enjoy video or
audio with the simplest operation. If your video/audio player (such
as a DVD player, CD player and VCR) and television or/and
amplifier/receiver support the JVC AV COMPU LINK system and
are tied with the JVC AV COMPU LINK cable(s), simply starting
the player will automatically make all necessary settings on the
television and/or amplifier/receiver to allow you to enjoy the
playback.

Connection and setup

Using an AV COMPU LINK cable, connect the AV COMPU LINK
terminals of each component to one another.
• The center unit setting for AV COMPU LINK is controlled using
the OTHERS menu in the preference display (see page 33).
• Refer also to the instruction supplied with your TV or VCR.
Center unit
• If you connect the center unit to a television via AV COMPU
LINK, set the center unit's AV COMPU LINK setting as follows.
When connecting to the VIDEO-1 input terminal of the
•
television: DVD2
When connecting to the VIDEO-2 input terminal of the
•
television: DVD3
When connecting to the VIDEO-3 input terminal of the
•
television: DVD1
37
IMPORTANT
When you make video connection between the player and another
device (such as a TV) via the composite, S-video or component
jacks, as well as AV COMPU LINK connection, see also the
instruction manual of the other device.
Notes for connection
• There may be no description about connections to the player in
the instruction manual of a television or VCR. However, a
television or VCR with AV COMPU LINK terminals indicating
"II," "EX" or "III" can be connected to the player.
Operation
The JVC AV COMPU LINK system allows you to enjoy video and/
or audio by simply pressing Play on the source component (the
component which plays back the video or audio, such as a DVD
player or VCR). You do not even have to switch on power on the
TV.
1
Turn on the main power of the
television.
2
Insert a disc (or tape) into the source
component.
3
Press 3 of the source component.
TV
The following actions are performed automatically:
• Turning on the television power.
• Setting the source of the television to the external input
(VIDEO-1, VIDEO-2 or VIDEO-3).