Basic Operations; Turning The System On/Off - JVC TH-S3 Manual De Instrucciones

Basic operations

The buttons on the remote control are used to explain most of the
operations in this manual. You can use the buttons on the center
unit same as on the remote control for operations unless
otherwise noted.
IMPORTANT
Before using the remote control for the following
operation,
• Set the remote control mode selector to AUDIO.
The buttons described below are used on
pages 13 to 15.
Source
selecting
buttons
13

Turning the system on/off

On the remote control:
Press
On the center unit:
Press
AUDIO
When DVD is selected as the source (see page 14), the following
messages will appear on the TV screen.
• "OPEN"/"CLOSE":
• "NOW READING":
• "REGION CODE ERROR!":
Remote control
mode selector
• "NO DISC":
• "CANNOT PLAY THIS DISC":
NOTE
• The STANDBY lamp goes off when the power is turned on, and the
lamp lights when the power is turned off.
• A small amount of the power is consumed even when the power is
turned off. This is called standby mode and the STANDBY lamp
lights in this mode. Unplug the power cord from the AC outlet to turn
the power off completely.
• You can also turn on the system by pressing the following buttons;
•
•
•
AUDIO.
.
Appears when opening or closing the disc tray.
Appears when the system is reading the disc information.
Appears when the Region Code of the DVD VIDEO does not
match the code the system supports. The disc cannot be
played back.
Appears when no disc is loaded.
Appears when unplayable disc is loaded.
OPEN/CLOSE on the remote control or 0 on the center unit
One of the source selecting buttons on the remote control
3 on the center unit. You can use the same buttons on the remote
control except after pressing FM/AM.