Connecting To An Analog Component; Connecting To A Digital Component; Connecting The Power Cord - JVC TH-S3 Manual De Instrucciones

Connections
Connecting to an analog
component
You can enjoy the sound of an analog component.
To audio output
VCR
Cassette recorder
NOTE
• If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this system, the sound output
through this system may be distorted.
• When playing a video component such as a VCR;
To listen to the sound, select "AUX" as the source to play. (See
•
page 14.)
To see the picture, connect the video output jack of the component
•
to the video input jack of the TV directly, and select the correct
input mode on the TV.
Do not connect the power cord until all other connections have been made.
Center unit
RCA pin plug cord
(not supplied)
TV
Connecting to a digital
component
You can enjoy the sound of a digital component.
Center unit
Digital optical cord
(not supplied)
* DBS = Direct Broadcasting Satellite
NOTE
When playing a video component such as a DBS tuner;
• To listen to the sound, select "AUX DIGITAL" as the source to play.
(See page 14.)
• To see the picture, connect the video output jack of the component to
the video input jack of the TV directly, and select the correct input
mode on the TV.
Connecting the power
cord
Make sure that all other connections have been completed.
Center unit
Power cord
Plug into AC outlets.
CAUTION
• Disconnect the power cord before cleaning or moving the system.
• Do not pull on the power cord to unplug the cord. When unplugging
the cord, always grasp and pull the plug so as not to damage the cord.
NOTE
• Preset settings, such as preset stations and surround mode adjustment,
may be erased in a few days in the following cases;
If you unplug the power cord of the center unit.
•
If a power failure occurs.
•
• If the wall outlet does not match the AC plug, use the supplied AC
plug adaptor.
*
DBS tuner
MD recorder
To digital optical
output
10