Engine Operation; Before Starting; Fuel Feeding - TOHATSU MFS 6BZ Manual Del Propietário

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-A
CAUTION
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine. (To
properly fill the engine with oil follow the
instructions. See page 62)
ENOW00027-A
CAUTION
Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock and
crank approximately 10 times in order to
prime the oil pump.
ENOM00044-C

1. Fuel feeding

ENOW00029-A
WARNING
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out through the fuel tank cap in
case the cap is loosened by using another
procedure when internal pressure of fuel
tank is raised by heat from sources such as
sun light.
ENOW0947-0
When using a separate tank, be sure that
the fuel line is not kinked and is connected
securely.
1. Full open the air vent screw on the fuel
tank cap.
ENOF01409-0
1. Air vent screw
2. Fuel tank cap
2. Open the fuel tank cap slowly and
release internal pressure completely.
After that, close the fuel tank.
3. Connect the fuel connector to the
engine and fuel tank.
1. Fuel connector
2. Push
3. Insert
CAUTION
1
2
1
3 3
35
7
ENOF00417-0
2
2 2
ENOF00514-0