Engine Operation; Before Starting; Fuel Feeding - TOHATSU MFS 4C Manual Del Propietário

ENGINE OPERATION

ENOM00042-0

Before starting

ENOW00022-A
CAUTION
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before star ting engine. ( To
properly fill the engine with oil follow the
instructions. See page 49)
ENOW00027-B
CAUTION
Before starting engine for the first time after
reassembling engine or off-season storage,
disconne ct stop switch lock and crank
approximately 10 times in order to prime the
oil pump.
ENOM00044-C

1. Fuel feeding

ENOW00029-A
WARNING
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out through the fuel tank cap in
case the cap is loosened by using another
procedure when internal pressure of fuel
tank is raised by heat from sources such as
sun light.
ENOW00403-0
When separate tank is used for dual tank
model, be sure to open air vent of integral
tank as well as air vent of separate tank. If air
vent of integral tank that contains fuel is
closed, swelling of air in the tank by heat
from engine can cause increase of internal
pressure of the tank dangerously.
1. When using integral tank
Loosen the air vent screw on the tank
cap by two turns.
When using separate tank
Full open the air vent screw on the
tank cap.
2. Open the fuel tank cap slowly and
release internal pressure completely.
3. Set fuel cock lever to which you
ENOF00454-0
would like to use.
ENOW00404-0
When using integral tank, disconnect fuel
connector.
ENOW00947-0
When using a separate tank, be sure that the
fuel line is not kinked and is connected
securely.
4. If you use a separate tank, connect
the fuel connector to the engine side
with pushing fuel connector lever.
CAUTION
ENOF00422-0
CAUTION
CAUTION
31
7