Chauvin Arnoux C.A 6030 Manual De Instrucciones página 64

=> Use the key to choose the desired type of test (sweep or pulse) :
Initial state
(1 st press, long)
( 2 nd press)
rd
( 3 press)
( 4 th press)
th
( 5 press)
( 6 th press)
Any prolonged additional press on the
The table below presents the test modes accessible according to the rating I
Type of signal: full-wave
Rating I
∆
N
Sweep
Pulse at:
I
∆
N
2 x I
∆
N
5 x I
∆
N
Pulse at 150 mA
Pulse at 250 mA
Type of signal: half-wave
Rating I
∆
N
Sweep
Pulse at:
I
∆
N
2 x I
∆
N
5 x I
∆
N
Pulse at 150 mA
Pulse at 250 mA
Remarks :
- in the "pulse" mode, the indicated test current value is the RMS current in the case of a full-
wave test, but the peak current in the case of a half-wave test (the test current is alway s ( I
- in the "sweep" mode, the applied current (RMS for a full-wave test, peak for a half-wave test)
is proportiona l to I
∆N
=> Connect the tripod plug to the instrument and the line power plug (or the 3 separate cables) to the
installation to be tested: the connection diagrams are the same as for the test without triggering
(see § 4.2.1.2).
Test in "sweep" mode
Test in "pulse" mode at I
Test in "pulse" mode at 2 x I
Test in "pulse" mode at 5 x I
Test in "pulse" mode at 150mA
Test in "pulse" mode at 250mA
Return to test in "sweep" mode
key causes an exit from programming of the type of test.
10 mA 30 mA 100 mA
yes yes yes
yes yes yes
yes yes yes
yes yes yes
yes
yes NO
yes
yes NO
10 mA 30 mA 100 mA
yes yes yes
yes yes yes
yes yes yes
yes yes
NO
yes yes
NO
yes yes
NO
(see § 4.2. 2.5.1).
64
∆N
∆N
∆N
∆ ∆ ∆ ∆ ∆ N
300 mA 500 mA
yes yes
yes yes
yes if ≤ 325 mA
yes NO
yes if ≤ 130 mA
NO NO
yes if ≤ 30 mA
NO NO
yes if ≤ 50 mA
NO NO
300 mA 500 mA
yes yes if ≤ 320 mA
NO
yes if ≤ 320 mA
yes NO
yes if ≤ 160 mA
NO NO
yes if ≤ 65 mA
NO NO
yes if ≤ 15 mA
NO NO
yes if ≤ 30 mA
NO NO
chosen.
"var.»
yes
yes
«var.»
),
∆N