Troubleshooting - Medela Swing Maxi Manual De Instrucciones

10. Troubleshooting

Problem
28
If the motor
is not running
If there is loss
of power during
battery operation
If there is low
or no suction
The pump
becomes wet
If condensation
appears in
the tubing
Solution
Check presence of mains current.
Check the position of the batteries in the battery compartment.
Replace batteries.
Check all connections.
Engage cap correctly at the three connection points.
Hold the breast shield, not the connector or bottle, while expressing.
Ensure the breast shield forms a complete seal around the breast.
During single pumping, insert the unused tubing into the tubing
holder. Do not kink the tubing.
There should be no water in the tubing.
All components must be completely dry.
Unplug the mains adapter from the socket.
Switch off the pump.
Do not place the pump upside down. Control panel must point
upwards.
Store the pump in a dry, warm place for 24 hours.
Note:
Do not expose the pump to direct sunlight.
Do not accelerate the drying process by use of heat.
Rinse out the tubing.
Shake out any water droplets.
Hang up the tubing to air-dry.