Controlnet Interface - Mettler Toledo IND780 Manual De Instalación

IND780 Installation Manual
Figure 2-66 shows the PROFIBUS board used in Panel Mount installations, with
the appropriate connector circled.
Figure 2-67 shows (from left to right) the module installed in the panel mount
enclosure, with the connector attached, and the rear panel in place.

ControlNet Interface

The ControlNet PLC Module (Figure 2-68, Figure 2-69) connects to the ControlNet
network via one or two coaxial cables (Figure 2-69). Channel B is redundant with
Channel A, and is not used unless ControlNet detects no signal on Channel A. Note
that the module's address is set in software, and the MAC ID switches indicated in
Figure 2-69 are not used.
2-40
Figure 2-66: PROFIBUS PLC Module for Panel Mount Enclosure
Figure 2-67: PROFIBUS PLC Module Connector for Panel Mount Enclosure
Figure 2-68: ControlNet PLC Module