Harsh Enclosure - Mettler Toledo IND780 Manual De Instalación

IND780 Installation Manual
Loosen and remove the eight, 8 mm shoulder nuts holding the backing plate to the
enclosure. The gasket should remain in position on the terminal. Figure 2-4 shows
two images of the enclosure, one with the backing plate removed to show the
gasket, the other with the backing plate installed.
Figure 2-4: Gasket on Enclosure (left) and Backing Plate Installed (right)
Place the terminal through the cutout from the front and secure by fitting the
backing plate over the back of the terminal, then installing and tightening the eight
nuts until secure. Figure 2-5 shows a side view of a panel installation.
Figure 2-5: Panel Mounting, Side View

Harsh Enclosure

The harsh enclosure is made of stainless steel and designed to rest on a flat
surface such as a table or desk top, or to be mounted to a vertical surface with
optional mounting brackets. In desktop configuration, the front panel angle is
approximately 70 degrees from vertical. In wall mount configuration, the front
2-5