Attaching The Enclosure To The Brackets - Mettler Toledo IND780 Manual De Instalación

Setting Front Panel Orientation
Establish whether the terminal will be mounted above or below eye level. If it will
be mounted at or below eye level, the orientation of the front panel must be
reversed. Follow these steps:
1. Open the enclosure as described in the Opening the Enclosures section.
2. Loosen and remove the two nuts securing the two metal cables (Figure 2-7)
that hinge the front cover to the rear housing.
Figure 2-7: Ground Strap Attachment Locations
3. Carefully rotate the front cover 180 degrees and reattach the two grounding
straps to the two studs near the grip bushings using the two nuts removed in
the previous step. Figure 2-8 shows one of the studs. Tighten the two nuts.
Figure 2-8: Stud for Attaching Reversed Front Panel

Attaching the Enclosure to the Brackets

Once the brackets are securely fastened to the wall surface, the enclosure can be
mounted to them using the four supplied M5 screws. One bracket is shown in
Figure 2-9, with the slotted holes indicated. The screws are tightened by fitting the
screwdriver through the slotted holes.
Figure 2-9: Wall-Mounting Bracket
Terminal Mounting
Holes
Slotted Wall-Mounting Holes
IND780 Installation Manual
Stud
2-7