Ethernet / Ip And Modbus Tcp Interface - Mettler Toledo IND780 Manual De Instalación

IND780 Installation Manual

Ethernet / IP and Modbus TCP Interface

The Ethernet / IP Module (Figure 2-72, Figure 2-73) connects to the network via a
standard Ethernet patch cable. The module's address is set in software, and the
DIP switches indicated in Figure 2-73 are not used and must all be set to OFF.
Note: For use in a Modbus TCP network, the module must be version 1.32 or
higher.
Figure 2-74 shows the array of status indicator LEDs on the Ethernet / IP card (see
also Figure 2-73).
2-42
Figure 2-72: Ethernet / IP PLC Module
RJ-45 DIP Switches for MAC ID (not
Connector used, must be set to OFF)
Figure 2-73: Ethernet / IP PLC Module Components
Link Activity
Activity
Figure 2-74: Ethernet / IP Status Indicator LEDs
1 2
Module Status
4 3
Network Status
LED Status
Indicators