Charging The Battery; Cleaning - Turbo LEVO Manual De Usuario

WARNING! Place the charger (and battery if removed from the frame) on a stable, level surface
unaffected by heat. You should charge the battery in a dry, well ventilated area and make sure the
charger is uncovered during the charging process. Ensure that the battery and charger are not exposed
to any flammable or dangerous substances. Plug the charger's plug into an outlet (100 - 240V), using
the appropriate plug for the country's standards, then connect the charging plug with the charging
socket on the battery. Specialized recommends charging the battery in an area with a smoke detector.
8.6
CAUTION: ALWAYS
TURN OFF THE
BATTERY BEFORE
PLUGGING OR
UNPLUGGING!
Fig. 8.6: Locate the charging socket on the non-drive-side of the battery, near the bottom bracket.
„
Fig. 8.6: Turn off the battery and unplug the wiring harness before removing the battery from the frame!
„
Fig. 8.6: Insert the charging plug into the charging socket. The four green LEDs next to the charging socket
„
indicate the level of charge in the battery in 25% increments.
Below is a list of helpful cleaning instructions.
Always turn the battery off and remove the charger from the battery and wall socket before cleaning the bicycle.
„
Leave the battery in the frame and leave the wiring harness plugged into the charging socket when washing/
„

cleaning.

Should it be necessary to remove the battery before cleaning, cover the wiring harness with a plastic bag to
„
protect it from water and dirt.
Before inserting the battery, ensure the battery and internal down tube surfaces are thoroughly clean and dry.
„
Whenever the battery is removed, use a soft brush or cloth to clean the inside of the downtube and the battery
housing.
CAUTION: Never use a high-pressure cleaner or hose when cleaning your LEVO. Best practice is to
use a bucket of water with a wet cloth or a sponge to remove dirt, then dry off all surfaces with a
clean towel. For instructions on how to clean drivetrain components, please refer to the drivetrain
manufacturer's instructions.
Make sure connectors are dry and clean before reconnecting and riding. Ask your Authorized
Specialized Retailer for additional information about cleaning your bicycle.
CAUTION: Do not use alcohol, solvents or abrasive cleaners to clean the charger or battery.
Instead, use a dry or slightly damp cloth.
15

8.5. CHARGING THE BATTERY

CHARGING SOCKET
8.6. CLEANING
CHARGING PLUG
WIRING HARNESS