General Information About Your Levo; Intended Use; Pedelec / Epac; Starting The System - Turbo LEVO Manual De Usuario

3. GENERAL INFORMATION ABOUT YOUR LEVO

The LEVO is intended and tested for All Mountain mountain biking (Condition 4) use only.
For more information on intended use and structural weight limits for the frame and components, please refer to the
Owner's Manual.
Before using your LEVO bicycle, please inform yourself of all applicable legal requirements and
regulations in your country or state. There may be restrictions on riding your LEVO bicycles
on public roads, cycling paths, and/or trails. There may also be applicable helmet and light
requirements, age restrictions or license or insurance requirements. Specialized does not, and will
not, make any promise, representation, or warranty regarding the use of your LEVO bicycle. As
laws and regulations regarding electric bicycles vary by country and/or state and are constantly
changing, please make sure to obtain the latest information. You should also regularly see your
Authorized Specialized Retailer for updated information.
CAUTION: All LEVO bicycles have a fixed pre-set speed limit at which the motor support will
automatically shut off. Any (attempted) tampering with the power output and/or system is
prohibited and will void the warranty.
Your LEVO is classified as a EPAC (Electrically Pedal Assisted Cycle, otherwise known as a Pedelec), and is
referred to in this manual as a bicycle unless otherwise noted. Your motor support will automatically switch off
when you reach a maximum speed of 25 km/h (15.5 mph) or 20 mph in the US/Canada. A driver's license or
insurance is typically not required.
Per EN 15194: The A-weighted emission sound pressure level at the driver ears is less than 70 dB(A).
To start the system, press and hold the
„
POWER button located on the TCU top
tube LED display unit (Fig. 3.1), until the
horizontal LEDs glow blue. The number of
LEDs that glow blue will depend battery
charge level.
To turn the battery (and support) off again,
„
press and hold the POWER button until the
LEDs turn off.
To switch support modes, press the MODE
„
button on the display (cycles through TRAIL
> TURBO > ECO) or the remote (+ or - buttons
to go up or down through the modes).
3

3.1. INTENDED USE

3.2. PEDELEC / EPAC

3.3. STARTING THE SYSTEM

3.1
MODE
POWER