Remote - Turbo CREO SL Manual De Usuario

The Road Remote is standard on some CREO SL models and controls the level of motor support. The road remote
is available through your local Authorized Specialized Retailer.
REMOTE INSTALLATION
The remote buttons can be installed in multiple places along the handlebar. When installing, make sure the position
is easily accessible and is comfortable to use.
CAUTION: Ensure that the cable does not interfere with handlebar movement and the cables do
not pull on the connectors when steering.
Remove any existing bar tape from the handlebars. Remove all old adhesive from the areas you are installing the
„
remote buttons. Make sure the handlebar is clean and dry before installing the remote buttons.
Unscrew the TCU and remove the TCU from the frame.
„
5.3
2 mm
Replace the drive side internal cable routing port with the supplied port (S182000003) (Fig. 5.3).
„
Guide the two remote connectors through the ICR port on the drive side and out through the top tube TCU cutout
„
(Fig. 5.4).
For bikes equipped with a dropper post, make sure to insert the dropper post housing after the
remote cables are routed.
The new ICR port (S182000003) can be found in the small parts box supplied with your bike. If
required, the part is available from your authorized Specialized retailer.
5.5
B
Remove the cover tape from the adhesive strip on the underside of the remote button (Fig. 5.5 a).
„
Install the remote buttons in the preferred position on the handlebar. Secure the cable on the handle bar with
„
tape to protect against pulling on the remote connections (Fig. 5.4 b).
9

5.4. REMOTE

5.4
A
B