Maintenance; Daily; Weekly; Periodical - Rancilio Epoca E1 Uso Y Mantenimiento

11. MAINTENANCE

Maintenance operations have to be carried
out when the machine is off and cold and
the plug is disconnected. Some particular
operations have to be effected when the
machine is operating.
Do not clean the machine by using metal or
abrasive devices, such as steel wool, metal
brushes, needles, etc. or general detergents
(alcohol, solvents, etc.)
When necessary, use special detergents
for coffee machines that can be bought in
specialized service centres.
11.1. Daily (Fig.9)
Use a clean cloth or sponge that does not leave hairs
or fluff (preferably cotton or linen).
● Carefully clean the outside surface, following the
grain of the satin finish on the parts in stainless
steel.
● Clean the steam and hot water spouts, check that the
nozzles are not encrusted (if they become encrusted,
be careful not to deform or damage them).
● Clean the spray units and the seals under the ca-
sing of the delivery units using the special brush
supplied
● Remove the filter-holders of the machine and re-
move the filters and the clamp which secures the
filter, use a brush to remove any coffee deposits
and rinse with hot water in order to dissolve any
grease deposits.
Model S1 TANK
operation to be carried out when the ma-
chine is off and cold and the plug is discon-
nected.
● Remove the lid on the water-tank;
● Remove the air trap C and softener A (Fig.7);
● Take out the water-tank, empty and clean it;
● Thoroughly rinse the water-tank and replace it in
the machine;
● Place the air trap in its guide and the softener
horizontally on the bottom of the water-tank;
● Fill the tank with clean water and close the lid.
if the air trap is not in the correct position,
the machine cannot heat or indicate a lack
of water in the tank.

11.2. Weekly

operations to be carried out with the machine
operative and under pressure.
● Place the supplied blind filter in the filter-holder,
put in a spoonful of detergent in powder for coffee
machines and fit the filter-holder in the unit to be
cleaned.
● Press the coffee dispensing button and draw water
for approx. 30 seconds.
● Stop and start dispensing several times until clean
water comes out of the discharge unit tube.
● Remove the filter-holder, take out the blind filter and
insert a normal one.Replace the filter-holder on the
unit and rinse by drawing water several times.
● Make a coffee to eliminate any unpleasant taste.
Cleaning the filters and delivery heads
Operation to be carried out when the machine is off
and cold.
● Prepare a solution of 4 sachets of detergent powder
Code 6000124 dissolved in a litre of boiling water
in a stainless steel, plastic or glass recipient (NOT
ALUMINIUM OR IRON).
● Remove the filters and immerse them with the filter
holders in the prepared solution, leaving them for
at least 10/20 minutes (all night is better).
● Remove them from the container and rinse them
thoroughly in running water.
Tank cleaning (Fig.10 - 11)
● Remove the cup-stand grille 1 at 2 (Fig.10) and
clean.
● Check and clean the drainage sump 3 (Fig.11),
removing any sludge with the help of a spoon.
11.3. Periodical maintenance
operation to be carried out with
the machine under pressure.
● Discharge the water from the boiler with hot water
delivery switch 5
● Wait until the machine has returned to heat equi-
librium before reuse.
5