Mounting The Loop Handle; Adjusting The Throttle Cable - Stihl FC 85 Manual De Instrucciones

Mounting the Loop Handle

2
3
A
: Fit the loop handle (1) on the drive
tube 8" / 20 cm (A) forward of the
control handle (2).
:
Position the clamp (3) against the
drive tube and slide it into the loop
handle.
FC 85
1
: Fit square nut (4) in the loop handle,
insert the clamp screw (5) from the
other side and tighten down
securely.
Adjusting loop handle to most
comfortable position:
:
Release clamp screw (5).
:
Move the loop handle along the
drive tube as required - retighten the
clamp screw.
Adjusting the Throttle
Cable*
4
5
50 mm
( 2" )
:
*
English / USA
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
handle must be in the normal
operating position.
Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
see "Guide to Using this Manual"
15