After Sale Service - SATA SATAjet 4000 B Instrucciones De Servicio

<< Operating Instructions SATAjet 4000 B RP/HVLP (DIGITAL) >>
EN
Malfunction
Material leaks from
behind the paint nee-
dle sealing
Spray gun leaks from
the fluid tip ("fluid tip
aperture")
11. Disposal
Recycle the completely empty spray gun. To protect the environment, bat-
teries and residual paint have to be disposed in an appropriate way and
separately from the spray gun. Please observe local legislation!

12. After Sale Service

Accessories, spare parts and technical support may be obtained from
your SATA dealer.
13. Warranty / Liability
The SATA General Conditions of Sale and Delivery and further contrac-
tual agreements, if applicable, as well as the valid legislation at the time
apply.
SATA cannot be held liable especially in the following cases:
• When the operating instructions are disregarded.
• When the product is used in other than the intended ways of usage.
• When untrained staff is employed.
• When no personal protection equipment is worn.
• When no original accessories and spare parts are used.
• When the product is manipulated, tampered with or technically modi-
fied.
• In case of normal wear and tear.
• In case when the product has been exposed to untypical shockloads
and impacts during usage.
• Assembly and disassembly
VII.14
Cause
Defective or missing
paint needle sealing.
Clogged or damaged
paint needle.
Contamination be-
tween paint needle tip
and fluid tip
Damaged nozzle set.
Corrective Action
Replace / insert paint
needle sealing, chap-
ter 9.3
Replace nozzle set,
chapter 9.1; replace
paint needle sealing, if
necessary, chapter 9.3
Clean fluid tip and
paint needle, observe
chapter 8
Replace nozzle set,
chapter 9