<< Operating Instructions SATAjet 4000 B RP/HVLP (DIGITAL) >>
4.
Design of the Paint Spray Gun [1]
[1-1] Paint spray gun handle
[1-2] Trigger
[1-3] Nozzle set consisting of air
cap, fluid tip (not visible),
paint needle (not visible)
[1-4] Paint spray gun connection
with QCC
[1-5] Gravity flow cup connection
with QCC
[1-6] Paint strainer (not visible)
[1-7] Gravity flow cup
[1-8] Gravity flow cup lid
[1-9] Anti-drip device
[1-10] Round/flat spray control
5.
Intended use
The paint spray gun has been designed for the application of paints. lac-
quers and other sprayable media by means of compressed air on suitable
substrates and surfaces.
6.
Safety Instructions
6.1. General Safety Instructions
• Before using the paint spray gun, please read all safety and the op-
erating instructions carefully. Safety instructions and indicated safety
measures are mandatory.
• Please keep all enclosed documents and make sure that the spray
gun is handed over only together with these documents.
[1-11] Material flow control screw
[1-12] Material flow control counter
[1-13] Air micrometer (aif flow con-
[1-14] Air micrometer (air flow con-
[1-15] Air piston (not visible)
[1-16] Compressed air connection
[1-17] ColorCode-System (CCS)
[1-18] Front cover of the pressure
[1-19] Pressure display (only with
Warning! Attention!
nut
trol knob)
trol) locking screw
display (only with DIGITAL)
DIGITAL)
EN
VII.3