Publicidad
Idiomas disponibles
Idiomas disponibles
Theporcelain o ntheburner i sdurable butovertime andwith
usemaygradually loseitsshine.
The threesealed surface burners a resecured t othecooktop
andareNOTdesigned t obe removed b ytheconsumer.
Select m odels feature onespecial POWER BOOST sealed
burner located at thefront.Usethisburner t oquickly bring
watertoa boil.
Cleanburnercap aftereachuseespecially if a spillover
occurs. Asoiledburner m ayresult i nimproper ignition or an
uneven flame.Whencleaning the sealedsurface burner,
usecaretoprevent damage totheignitor. I fa cleaning c loth
should catch theignitor, i tcouldbedamaged o rbroken.
If burner doesnot light:
1.Thesurface burner w illnotlightiftheignitor i s damaged,
broken, s oiled or wet.Theburner willalsonotlightifthe
ports, e specially t hesmall p ortlocated directly below the
ignitor, a reblocked.
2. Check toseeiftheburner ports areclogged. I f so,clean
witha straight p inor small m etal p aper clip.
SEALED
BURNER
HEAD
i orts
Your RV range or cooktop will feature three surface burners.
Each burner is secured in place with a screw. When burner is
cool, remove the screw before removing the burner. When
re-installing the surface burner be sure to replace the screw.
If the surface burner does not light, check to see if the burner
ports are clogged. If so, clean with a straight pin or small
metal paper clip. Be sure the standing pilot is lit. Check to be
sure that the burner is correctly installed.
To install surface burner: The air shutter end on the burner
should fit over the orifice hood.
-.
Orifice Hood
To install
surface burner with Piezo ignition:
The two
tabs on each flashtube should be securely inserted into the
two slots on each burner head.
kl_ _
Two
Tabs
The flashtube "hold down" clips should secure the flashtube
in place. The clips are located under the metal shield.
Flash
LJ
down"
3 BURNER COOKTOP
Publicidad
