Important - Maytag Amana Magic Chef CLY1620BDS12 Manual De Instrucciones

The surface burners will feature either matchlit ignition or
Piezo pilotless ignition. Be sure all control knobs are in the
OFF position before supplying gas to the appliance. Be sure
gas supply to appliance is on before lighting burner.
To prevent damage to the cooktop or pan:
• Never operate the surface burner without a pan in
place.
• Never allow a pan to boil dry.
• Never operate a surface burner on HIGH for
extended periods of time.
CAUTION: If the burner does not light within about 4
seconds or if the flame should go out during cooking, turn
the burner off. If gas has accumulated and a strong gas
odor is detected, open a window and wait 5 minutes for
the gas odor to disappear before relighting the burner.
If the appliance has not been operated for a period of time,
the surface burner may be difficult to light due to air in the gas
line.
To bleed off air from the line:
1. Hold a lighted match next to the burner.
2. Turn the surface burner control knob to the LITE position.
3. When the burner lights, turn the knob back to the OFF
position.
4. Proceed as directed below.
To light surface burner with matchlit ignition:
1. Place a pan on the burner grate.
2. Hold a lighted match next to the desired surface burner
head.
CAUTION: Do not turn the control knob on and allow gas
to escape before lighting the match.
3. Push in and turn the surface
burner control knob to the LITE
position.
4. When the burner lights, adjust
the knob between HI and LOW to
select the desired flame size.
,A\ LITE
5. After cooking, turn the surface burner control knob to the
OFF position.
To light surface burner with Piezo ignition:
1. Place a pan on the burner grate.
2. Push in and turn the surface
burner control knob to the LITE
position.
IMPORTANT: Only light one
surface burner at a time.
.
Immediately, rotate the TOP
BURNER IGNITOR knob to the
right (clockwise) several clicks
until the burner lights. The burner
should light within 6 clicks or one
full rotation of the knob.
,A\ LITE
4. When the burner lights, adjust the surface burner
control knob between HI and LOW to select the desired
flame size.
5. After cooking, turn the surface burner control knob to the
OFF position.
To operate burner if the Piezo ignitor is not functional:
1. Be sure all controls are in the OFF position.
2. Hold a lighted match to the desired surface burner head.
CAUTION: Do not turn the control knob on and allow gas
to escape before lighting the match.
3. Push in and turn the surface burner control knob to the
LITE position.
4. When the burner lights, adjust the knob between HI and
LOW to select the desired flame size.
5. After cooking, turn the knob to the OFF position.
When the recreational vehicle is not in use or while traveling,
turn all knobs to the OFF position and turn off the main gas
supply.