Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS
'
CLEANING AGENTS
'
DIRECTIONS
Silicone rubber
• Soap and water
Wash with soap and water, rinse and dry. Do not remove door gasket.
• Door gasket
remove finger marks or smudges. Use cleansing powders or plastic
t
NOTE: For discoloration, use a stainless steel cleaner and a soft cloth.
|
:
Rinse immediately and dry.
Surface
• Soap and water
For ease of cleaning, clean burners each time the cooktop is used with
burners, sealed
• Paste of baking soda and
warm soapy water. If a boilover occurs, remove pan to another burner;
select models
water
cool burner and clean. To remove stubborn soil, use a dry cloth and
• Plastic scouring sponge or
mildly abrasive cleanser. Use care to prevent cleaner from clogging
pad
pods. Burner must be dry before use.
• Mildly abrasive cleaner
NOTE: Yellow tipping or distortion of the flame may occur until the
burner is completely dry.
Clean burner ports with a straight pin or small metal paper clip. Do not
enlarge or distort ports. Do not use a wooden toothpick as it may break
off and clog port. If ports are clogged or soiled, the burner may not light
properly or the flame may not be even.
Sealed burner can not be removed by the consumer. When cleaning
burner, use care to prevent damage to the ignitor. Surface burner will
not light properly if ignitor is damaged, broken, soiled, or wet. When
cleaning the pods, be sure to clean the port directly below the ignitor.
I
• Soap and water
For ease of cleaning, remove soil from the burner as soon as burner
burners,
• Paste of baking soda and
has cooled. If food boils over, remove pan to another burner. Then,
conventional,
water
I cool soiled burner and clean.
select models
• Pastic scouring sponge or
I
pad
Clean when cool after each use with warm soapy water Hemove
• M d y abras ve c eaner
stubborn sol by scouring with a nonabrasive
plastic scouring pad and
I
a paste of baking soda and water Clean ports with a straight pin Do
not enlarge or distort the ports Do not use a wooden toothpick
It may
break off and clog port Surface burners can be dried in the oven set at
I
. 170°F. Burner must be dry before use.
Publicidad
