Speed Selection - 3M 6502 Manual Del Usuario

6.8 Speed Selection

Speed changes are made using these three keys: The 3M Electronic Pipettor II must be in one of the pre-programmed (d1, d2, d3, P1, d0) modes to
modify the speed selection:
Speed "1" is lowest and Speed "9" is fastest.
1. Press to display the aspiration speed.
2. Press to select a new aspiration speed.
3. Press when the desired aspiration speed is displayed. Dispensing
speed is then displayed.
4. Press to select a new dispensing speed.
5. Press when the desired aspiration speed is displayed. The display then returns to the diluent aspiration readout.
Speed Selection function may not be used in the middle of any aspiration or dispensing cycle.
5
SPEED
IN
5
SPEED
OUT
13
(English)