Wilo Stratos GIGA Serie Instrucciones De Instalación Y Funcionamiento página 44

English
No.
1.0.0.0
2.0.0.0
3.0.0.0
4.0.0.0
4.1.0.0
4.1.1.0
4.1.2.0
4.1.3.0
4.2.0.0
4.2.1.0
38
Designation Type Symbol Values/explanations
±
Setpoint
±
Control mode
±
Pump on/off
Information
Actual values
Actual values sen-
sor (IN1)
Switching fre-
quency
Power
Operating data
Operating hours
The condition for hiding a menu element is explained in the last col-
umn of the table.
Setting/display of the setpoint
(for further information, see
chapter 8.6.1 "Adjusting the
setpoint" on page 34)
Setting/display of the control
mode
(for further information, see
chapters 9.4 "Setting the control
mode" on page 47 and 6.2 "Con-
trol modes" on page 13)
Constant speed control
Constant p-c control
Variable p-v control
PID control
ON
Pump switched on
OFF
Pump switched off
Information menus
Display of current actual values
Depending on current control
mode.
p-c, p-v: Value H in ft
PID control: Value in %
HIGH
High switching frequency
(factory setting)
MID
Medium switching frequency
LOW
Low switching frequency
Current power input P in W
1
Display of operating data
Sum of the pump's active hours
of operation (counter can be
reset by infrared interface)
Display conditions
Not displayed for manual
control mode
Switchover/modification
must only be carried out
when pump is at standstill
(motor not running)
The operating data refer to
the module currently being
operated
WILO SE 01/2014