Wilo Stratos GIGA Serie Instrucciones De Instalación Y Funcionamiento página 49

No. Designation
5.5.1.0 P parameter
5.5.2.0 I parameter
5.5.3.0 D parameter
5.6.0.0 Error
5.6.1.0 HV/AC
5.6.2.0 Emergency opera-
tion speed
5.6.3.0 Auto reset time
5.7.0.0 Other settings
5.7.1.0 Display orientation
5.7.2.0 Pressure value cor-
rection
5.7.6.0 SBM function
5.7.7.0 Factory setting
Installation and operating instructions Wilo-Stratos GIGA
Type Symbol Values/explanations
±
Setting of the proportional term
of the control
±
Setting of the integral term of
the control
±
Setting of the derivative term of
the control
Settings for behavior in case of
error
±
HV "heating" mode
AC "cooling/air-conditioning"
mode
Display of emergency operation
speed
±
Time until automatic acknowl-
edgment of an error
±
Display orientation
Display orientation
±
When pressure value correction
is enabled, the differential pres-
sure deviation measured by the
differential pressure sensor that
is factory-fitted on the pump
flange is taken into account and
corrected.
Pressure value correction off
Pressure value correction on
±
Setting for behavior of signals
SBM run signal
SBM readiness signal
SBM mains on signal
±
OFF (default setting)
Settings are not changed by
confirming.
Display conditions
Only displayed in p-c mode.
Is not displayed for all pump
variants.
Is not displayed when
"access disable" is active.
Is not displayed when build-
ing management system
active.
43
English