Commissioning; Filling And Bleeding - Wilo Stratos GIGA Serie Instrucciones De Instalación Y Funcionamiento

English
No.
6.0.0.0
7.0.0.0
9

Commissioning

Safety
Preparation
9.1

Filling and bleeding

44
Designation Type Symbol Values/explanations
±
Error acknowledg-
ment
±
Access disable
ON
Confirming will reset the set-
tings to factory settings.
Caution!
All manual settings will be lost.
For additional information, see
chapter 11.3 "Acknowledging
errors" on page 59.
"Access disable" inactive
(changes possible)
(for further information, see
chapter 8.6.7 "Activating/deacti-
vating access disable" on
page 37).
"Access disable" active (no
changes possible)
(for further information, see chap-
ter 8.6.7 "Activating/deactivating
access disable" on page 37).
DANGER! Danger of death!
Failure to install safety devices of the electronic module and the
motor can cause electrical shock or contact with rotating parts,
potentially resulting in life-threatening injuries.
• Before commissioning as well as after maintenance work, all
safety devices such as module covers and fan cover that were
removed must be reinstalled.
• Keep a safe distance during commissioning!
• Never connect the pump without the module.
Before commissioning, the pump and module must be at ambient
temperature.
• Prime and bleed the system as required.
CAUTION! Damage to the pump!
Dry running will destroy the mechanical seal.
• Make sure that the pump does not run dry.
Display conditions
Is not displayed when
"access disable" is active.
Is not displayed when build-
ing management system
active.
Only displayed if an error is
present
WILO SE 01/2014