Stihl BF Manual De Instrucciones página 10

If the implement or deflector is blocked
or covered, always switch off the engine
and ensure that the tool has come to a
standstill before starting to clean it.
Grass, weeds, etc. should be cleaned off
the tool at regular intervals.
!
Important!
Check the tightness and condition of the
tool at regular intervals during cutting. If
the behaviour of the tool changes, stop
the engine immediately and examine the
tool. Cracked, bent, warped, damaged
or dull tools must be replaced
immediately. Such tools may shatter at
high speeds and cause injuries.
!
Important!
Keep your hands and feet
well clear of the tool.
Never touch a rotating
tool. The tool continues to
run for a short time after
releasing the throttle
trigger (coasting effect).
BF, BK
Major settings
!
Important!
To reduce the risk of injury due to loss of
control or contact with a moving tool,
never operate the machine with
incorrectly set idle speed. The tool
should not move if the idle speed has
been set correctly. Instructions for
adjusting the idle speed can be found in
the appropriate chapter of the owner's
manual for the power tool.
If the correct idle speed cannot be set,
have the machine checked and correctly
set or repaired by your STIHL service
dealer.
English / USA
MAINTENANCE, REPAIR AND
STORING
STIHL may refuse to acknowledge a
warranty claim if the component has
not been handled or serviced
correctly or if unauthorized spare
parts have been used.
!
Warning!
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non-STIHL parts may cause serious or
fatal injury.
Follow the maintenance and repair
instructions in the appropriate section of
your owner's manual. Please refer to the
maintenance chart on the last pages of
this manual.
Additionally, the daily maintenance
schedule for your power tool set forth in
your STIHL Owner's Manual should be
strictly followed.
9