English / USA
A
:
Apply a mark to the drive tube at
distance A of 50 mm (2 in)
(e.g. with a pencil or felt tip pen).
14
Mounting the Deflector
:
Slide the deflector (1) onto the drive
tube (2) until distance "a" is 100 mm
(4 in).
:
Line up the deflector on the drive
tube so that the machine support on
the powerhead and the longer part
of the deflector point up.
:
Tighten down the clamp screws (3)
firmly.
Check that the deflector is secure –
it must not be possible to rotate it on
the drive tube.
Mounting the Gearbox
:
Loosen the clamp screws (4).
:
Push the gearbox (5) onto the drive
tube (2) – turn the gearbox back and
forth as necessary until the housing
is approximately in line with the
mark.
BF, BK