Starting And Using The Machine - Dalla Corte DC PRO Manual De Usuario

Starting and using the machine

Follow all the instructions described below with
the help of picture 1:
• Open the water tap
is no leaking hose connection.
• Turn on the electrical switch
2
clockwise. Make sure the display turns on.
• Once the machine is on, the automatic level
starts filling up the boiler until the proper level
is reached. At this stage, the symbol
the display.
• After the filling phase, the group heads start
heating. The set temperature value blinks on the
display.
NOTE
The heating sequence starts only when the Timer is deactivated and the machine is turned on
after it has been completely switched off through the main switch
in order to save a good quantity of energy during the heating up of the machine, thus avoiding
problems of local electrical system overloading.
36
1
and make sure that there
7
and turn the knob
blinks on
• After the heating phase, the temperature values
stop blinking and the set value for each group is
shown.
• Straight afterwards, the boiler starts to heat up
and its set temperature value blinks on the display.
• During this phase, the brewing groups can be
used.
• When the boiler reaches the correct temperature,
the set value stops blinking and the unit will emit
2 bleeps confirming the machine is ready for use.
2
. This sequence is conceived