Safety; Explosion Protection - Nederman E-PAK 150 DX Manual De Instrucciones

EN E-PAK 150 DX/300 DX/500 DX
4
4.1
26
WARNING! Type of injury.
Warnings indicate a potential hazard to the health and safety of users.
They clearly state the nature of the hazard and how to avoid it. They appear at
their points of application in this document. They look like this notice, but with
different texts.
CAUTION! Type of risk.
Cautions indicate a potential hazard to the physical integrity of the equipment,
but not a danger to personnel. They clearly state the nature of the hazard and
how to avoid it. They appear at their points of application in this document.
They look like this notice, but with different texts.
NOTE!
Notes contain other information which the user should be especially
aware of.

Safety

To maintain a high level of safety when using E-PAK 150 DX/300 DX/500 DX,
consider the following:
• This unit is to be installed, used and maintained according to this
document in such a way that safety is maintained. This document contains
important warning directions which have to be observed. Any functional
faults, especially those affecting the safety of the machine, are to be
rectified immediately.
• We recommend that fire alarms and appropriate extinguishing systems are
to be installed at all locations where collected combustible dust is stored.
• Standards relating to the connection and use of filters in hazardous
areas are to be taken into consideration, especially national standards
for installation. Only trained personnel familiar with these standards is
allowed to handle this type of filters.
• This unit was specially designed to comply with official regulations
concerning the risk of explosion. If improperly used, incorrectly installed,
or altered, no matter to which extent, the safety and reliability could be
jeopardized.
• For E-PAK 150 DX/300 DX/500 DX to function properly and fulfil the
necessary safety requirements as stated in the declaration of conformity,
the complete system is to be assessed with regards to applicable safety
standards and directives and comply with all requirements described in
this document.
• The designer of the system as a whole, has to guarantee the correct
function of all interacting products or components and ensure that the
complete system meets all necessary safety requirements.
• Only authorized personnel is allowed to have access to this unit.
The filter is not to be used for filtering fumes from welding
•
processes.

Explosion protection

The CE and ATEX markings on this unit ensure both a high level of safety and
protection against ignition of the collected combustible dust. However, if an
explosion occurs due to misuse, insufficient maintenance or faulty installation,