Electrical Connections - Aventics DeviceNet VS LP04 Instrucciones De Servicio

20 AVENTICS | DeviceNet | R402000617–BDL–001–AC

Electrical connections

Table 4: Overview of LED displays
LED
ALL
Power Supply
Valve Sensor
Status A
Status B
MNS
1
2
Fig. 4: Round plug-in
connector X1S
Out
Illuminated Green
Flashes Green
Illuminated Green
Out Red
Illuminated Green
Flashes Red
Flashes Green
Out Red
Out Green
Flashes Red
Out Green
Illuminated Red
5
Fig. 3:
4
Pin 1:
Pin 2:
Pin 3:
Pin 4:
3 The electronic supply for the bus coupler is connected at X1S, Pin 1. The
switch voltage for the connected valves is fed in via X1S, Pin 2. In an
EMERGENCY OFF situation, it is possible to switch off all valves while the
PLC and serial interfaces continue to run, due to this separated power
supply. Switching off the power supply for the serial interface causes
the PLC to go to STOP mode.
Function
No supply voltage, not online
Supply within range
Not applicable
Bus driver supply missing
Operational / connected online
Defective communication
Received "Identity Comm. Fault Request"
Operational / not connected online
or online, not requested by master
Simple internal error
or connection timeout
Serious internal error
or critical connection error
Electrical connections
Plug position
24 V electronics
24 V valves
0 V
FE