entrematic Ditec ION4 Manual De Usario página 101

Problem
The remote control The radio transmission is im-
has limited range peded by metal structures and
and does not work reinforced concrete walls.
with the auto-
mation moving.
The remote control No storage module or incor-
does not work rect storage module.
The flashing light The wires of the flashing light
is not working are detached or have short
circuited.
Possible cause
47
Alarm
signalling
Install the antenna outside.
Replace the transmitter batteries.
Switch the automation off and plug in the
correct storage module.
Check the correct memorisation of the
transmitters on the built-in radio. If there
is a fault with the radio receiver that is
built into the control panel, the remote
control codes can be read by removing
the storage module.
Check the connections.
If the problem persists, contact Techni-
cal Service.
Operation
EN