Additional Em Level Parameters That Can Be Configured (Available With At → Aa Enabled); Second Level Menu - Ap (Advanced Parameters) - entrematic Ditec ION4 Manual De Usario

Display
LB - Indication that batteries are almost flat
00 - Visualisation on display (alarm message
01 - Visualisation on flashing light (with the automation idle, 2 flashes are
made and then repeated every hour) and on display (alarm message
02 - Visualisation on "open gate" indicator light (with the automation closed, 2
flashes are made and then repeated every hour) and on display
(alarm message
15.8.1 Additional EM level parameters that can be configured
(available with
Display
LL - Voltage threshold for indicating that batteries are almost
flat (V)
17 - Minimum
24 - Maximum
NB: it is set with an interval of sensitivity of 0.5 V shown when the
decimal point on the right lights up.
BT - Battery mode
00 - Anti-panic (performs the opening operation following a mains supply fail-
01 - Continuous operation - the last operation performed before control panel
02 - Continuous operation - the last operation performed before control panel

15.9 Second level menu - AP (Advanced Parameters)

Display
FA - Selection of opening limit switch mode
NO - None
SX - Stop limit switch (after activation, the gate stops its movement)
PX - Proximity limit switch (after activation, the gate continues as far as
FC - Selection of closing limit switch mode
NO - None
SX - Stop limit switch (after activation, the gate stops its movement)
PX - Proximity limit switch (after activation, the gate continues as far as
the end stop and any obstacle is considered a stop)
EN
)
→
Description
ure. The automation opens but does not accept any other commands until
the mains supply has been restored).
switch-off will be an opening.
switch-off will be an closure.
Description
the end stop and any obstacle is considered a stop)
Description
)
enabled)
36
Selections
available
)
Selections
available
22
Selections
available