Additional Ap Level Parameters That Can Be Configured (Available With At → Aa Enabled) - entrematic Ditec ION4 Manual De Usario

Ocultar thumbs Ver también para Ditec ION4:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 212
15.9.1 Additional AP level parameters that can be configured
(available with
Display
20 - Partial opening command of terminal 1-20
P3 - Partial opening command
1-2 - Enabling of automatic closure
1-9 - Stop input
LU - Setting the courtesy light switch-on time (s)
To enable the parameter, set the selection
light".
It is set with different intervals of sensitivity.
NO - Disabled
- from 01" to 59" with intervals of 1 second
- from 1' to 2' with intervals of 10 seconds
- from 2' to 3' with intervals of 1 minute
ON - Permanently enabled (switched off via remote control)
NB: the courtesy light switches on at the start of each operation.
LG - Switch-on time for independently commanded courtesy light
[s]
To enable the parameter, set the selection
light".
It is set with different intervals of sensitivity.
NO - Disabled
- from 01" to 59" with intervals of 1 second
- from 1' to 2' with intervals of 10 seconds
- from 2' to 3' with intervals of 1 minute
ON - Switched on and off with remote control
NB: the switching on of the light does not depend on the start of an
operation, but can be commanded separately using the special remote
control key.
PT - Fixed partial opening
ON - Enabled
OF - Disabled
If ON, a partial opening command given on the partial opening posi-
tion is ignored.
With contact 1-20 closed (for example with the timer or manual se-
lector), the gate will partially open. If it is then fully opened (command
1-3) and reclosed (even with automatic closure), it will stop at the
partial opening position.
DE - Disengagement setting if an edge is triggered [cm]
Regulates the disengagement distance when an edge (active or pas-
sive) is triggered during opening or closure.
00 - Deactivated
20 - Maximum
DO - Setting of disengagement on stop during opening [mm]
Regulates the distance of the disengagement on the mechanical
opening stop.
00 - Disabled
15 - Maximum
NB: not active if
EN
enabled)
Description
38
as "courtesy
as "courtesy
Selections
available
10
07

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ditec ion4jDitec ion6Ditec ion6j

Tabla de contenido