Pcb Jumper Positions - Mettler Toledo IND570 Manual De Instalación

2.6.

PCB Jumper Positions

Only the analog version of the Main board has a jumper on it. This section provides the details for
this jumper.
2.6.1. Main PCB Jumper
The IDNet, SICSPro and POWERCELL versions of the IND570 main board have no jumpers. There is
one jumper on the IND570 analog scale main board (W1). This jumper selects either 2 mV/V or
3 mV/V operation of the analog circuitry. 3mV/V is the factory default position. Refer to Figure
2-121 for the jumper location and Figure 2-122 for its settings.
30205319 | 11 | 07/2019
Table 2-12: Active/Passive Switch Position, DIO Option PCB
5 In/8 Out Option Boards
Figure 2-121: W1 Millivolt Jumper Location, Main PCB
METTLER TOLEDO IND570 Terminal Installation Manual
2 In/5 Out, COM2/COM3 Option Boards
W1
2-69