Irlanda; Monza And Monza-Vitro; Oxford And Zamora - Bronpi SYDNEY Instrucciones De Instalación, Uso Y Mantenimiento

2.1.2.

IRLANDA

This model of stove is provided with axial fans to improve the heat distribution by the ventilation.
The start and the control of the ventilation are made by the three-position switch placed on the right bottom side
(see drawing D23).
These three-positions have the following functions:
- 0 position: the fans are turned off when there is no combustion inside the chamber due to the stove is
provided with a thermostat that controls the fan according to the temperature of the stove.
- 1 position: the fans run in a low speed.
- 2 position: the fans run in a high speed.
• FANS CONNECTION:
In the right side of the stove you will find the cable that connects to the electricity network. It is advisable do not cut it in the entire length
because this section is useful when changes in the electrical components are needed.
It is obligated the correct connection of the installation to earth connection.
The installation of the system might be done by skilled labour and qualified under the current rules.
• REPLACEMENT OF THE FANS:
The replacement of the electrical components will be done by the
front of the stove. This way you do not have uninstall the stove,
please follow the next steps (see drawing D24).
- First of all, you will have to screw out the screws in both
sides of the fan protection.
- When this protection grille has been removed, you will have
a direct access to the fans.
- The electrical components of the system are placed on the
right side of the stove. To get access to them you will need
to screw out the right fan and remove it.
- Disconnect and replace the damaged elements and
reattach everything such as before.
D26
2.1.3.
The stove Monza has on the top two rings to be used as
a plate warmer. These rings should be handled with the
accessory included for this purpose (see drawing D25).
The mod. Monza Vitro instead of two cooking rings includes
on the top a hot plate (vitro ceramic glass) to be used as a
plate warmer (see drawing D26).
The worktop has in both sides two removable handles made in stainless steel.
The model Vitro has another one handle in the front of the worktop.
2.1.4.

OXFORD AND ZAMORA

The rotating cast is made in two parts: the iron grate and the handle in stainless steel. To place the grate follow the next steps:
1. First of all, we must introduce the rod by the hole on the front of the stove.
2. Place the grate with an approximated angle of 45º to introduce the hook of the rod on the hole of the
grate.
D28
In the same way, the model Zamora also includes a handle to remove the ash pan avoiding burns (see drawing D30).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS

MONZA AND MONZA-VITRO

3. Later, place the grate over the firebox (see drawing D27).
The firebox is removable too. To remove it follow the next steps:
1. Remove the vermiculite pieces (only model Oxford).
2. Remove the iron grate and the handle.
3. Finally turn the firebox approximately 45º to get it out by the door of
the stove (see drawing D28).
The model Oxford also includes a handle with a double function: remove
the ash pan and apply over the pull of the rotating cast doing possible to
move it avoiding burnings (see drawing D29).
20
D23
D24
D25
D27
STOVES