Husqvarna SMR 450-R 2009 Manual De Uso Y Mantenimiento página 102

ADJUSTING THE COMPRESSION FORK
a) COMPRESSION (LOWER REGISTER)
Standard calibration: -15 clicks.
Remove plug (B) and turn register (A) clockwise until the posi-
tion of fully closed is reached then, turn back by the men-
tioned clicks.To obtain a smoother braking action, turn the reg-
ister anticlockwise. Reverse the operation in order to obtain a
harder action.
a)
A
B
b)
C
32
b) EXTENSION (UPPER REGISTER)
Standard calibration: -15 clicks.
To reset standard calibration turn register (C) clockwise to
reach the position of fully closed; then, turn back by the men-
tioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
E
c) AIR VENT (to carry out after each competition, or monthly).
Place the vehicle on a central stand, pull the fork all out, then
remove the cap (E) and press the valve with a tip. Fit the cap
back in.
WARNING!
NEVER loosen the screw (F).
WARNING: Never force the adjusting screws
beyond the maximum opening and closure po-
sitions.
C
C
F