Husqvarna SMR 450-R 2009 Manual De Uso Y Mantenimiento página 111

REASSEMBLING THE FRONT WHEEL
Fit the L.H. spacer on the wheel hub.
Fit the wheel between the front fork legs.
Fit the wheel axle (2) from the R.H. side, after greasing it
and push it to the stop on the L.H. leg; during this operation,
the wheel should be turned. Tighten the screw (3) on the fork
L.H. side but DO NOT lock it. Now, pump for a while, pushing
the handlebar downwards until you are sure that the fork legs
are perfectly aligned. Lock: the screws (1) on the R.H. leg
(10,4 Nm/ 1,05 Kgm/ 7.7 ft-lb), the screw (3) on the L.H. side
(51,45 Nm/ 5,25 Kgm/ 38 ft-lb), the screws (1) on the L.H.
leg (10,4 Nm/ 1,05 Kgm/ 7.7 ft-lb).
Fit the brake caliper on the disc; assemble the caliper on its
holding plate and tighten the screws (A) at 25,5 Nm/ 2,6
Kgm/ 18.8 ft-lb.
Check that the brake disc slides between the caliper pads with-
out any friction.
NOTE
After reassembly, pump the brake control lever until the pads
are against the brake disc.
SMR-R
1
2
SMR-R
1
3
SMR-R
A
41