Checking The Oil Level - Husqvarna SMR 450-R 2009 Manual De Uso Y Mantenimiento

CHECKING THE OIL LEVEL

Keeping the motorbike level and in a vertical position, check the
oil level through the inspection (1) window on the right
crankcase. Make sure the level is in between the MIN and MAX
notches.
To fill up, remove the filler cap (2).
Note*: Have this operation made with war-
med-up engine.
WARNING*: Be careful not to touch hot engi-
ne oil.
1
MAX
MIN
2
20
ENGINE OIL REPLACEMENT AND BAG FILTERS-FIL-
TER CARTRIDGE CLEANING OR REPLACEMENT
WARNING*: Be careful not to touch hot en-
gine oil.
Drain the oil with WARM ENGINE; proceed as follows:
remove oil filler cap (2);
G
remove the engine guard;
G
place an oil drain pan under the engine block;
G
remove the oil drain cap (3);
G
drain the used oil completely then clean the magneto on
G
the cap;
A
3
remove the three filters (5), (6) and (7) on the L.H. side of
G
the engine, check O-Rings for wear then clean filters with
fuel; reassemble using the reverse procedure;
in order to replace the filter cartridge (4), remove the right
G
side engine guard), unscrew the three fastening screws
then the filter cartridge cover;
after filters replacement, reassemble the drain cap (3), the
G
engine guard (A), the right side engine guard (B), then
pour the recommended oil quantity.
B
4