Husqvarna SMR 450-R 2009 Manual De Uso Y Mantenimiento página 95

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

AIR FILTER CHECK
Turn rear pin (1) counterclockwise, remove the saddle from the
front afstening screw.
Remove screw (3) and the filter (4). Separate filter (5) from
frame (6).
4
3
AIR FILTER AND CLEANING
Wash the filter with a specific detergent (AGIP Filter clean
foam air detergent fluid" or similar) then dry it fully (wash fil-
ter with gasoline only in case of necessity).
Plunge the filter in special oil for filters (AGIP "Foam air filter
protection oil" or similar), then wring it to drain superfluous
oil.
CAUTION*: Do not use gasoline or a low fla-
sh-point solvent to clean the element. A fire
or explosion could result.
CAUTION*: Clean the element in a well ven-
tilated area, and do not allow sparks or fla-
1
mes anywhere near the working area.
ASSEMBLY
To ensure tight fit, slightly (C) grease filter edge on side facing
filter housing.
While re-inserting the filter into its housing, make surs that
piece A is turned upwards and edge B is on the left lower side
of the filter case. Reassemble the parts previously removed.
CAUTION*: If the element assembly is not
installed correctly, dirt and dust may enter
and the engine resulting in rapid wear of
the piston rings and cylinder.
A
25

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Smr 530-r 2009

Tabla de contenido