Packing The Apparatus - MSA S-Cap-Air Manual De Funcionamiento

PACKING THE APPARATUS

5. Packing the Apparatus
After filling the compressed air cylinder, the S-Cap-Air is packed away in the carry
bag as follows:
(1) Insert the end of the cylinder carefully into the large black internal loop in the
bag, holding the hood connected by the breathing tube carefully whilst doing
so. Fix the cylinder indicator through the slot of the small black internal loop.
The unit should be located in the bag in such a way that the breathing tube
lies along the cylinder up to the end and the hood lies on top in the opposite
direction. If the unit is packed correctly, the cylinder indicator is clearly visible
in the inspection window of the bag.
(2) Lay the yellow unzipping tape with the unzipping loop loosely along the
cylinder to the cylinder valve. Hook the clip on the end of the unzipping tape
into the start-up pin. Run the unzipping loop at the end of the unzipping tape
above the cylinder valve to the outside of the bag.
(3) Close the zipper completely up to the end over the tooth cut-out in the zipper
chain.
When doing this, keep the hood in the packed position and make sure that
nothing is caught in the teeth of the zipper and that the unzipping loop is
outside the bag.
(4) Make sure that the air pressure indicator can be seen through the window in
the bag.
(5) Push the orange strap of the bag at the end of the zipper through the
unzipping strap and place the eyelet on the orange strap above the eyelet on
the bag. Pull the seal through the eyelets on the bag and the strap.
This fixes the straps in position and secures the loop of the unzipping tape.
The sealing should be as tight as possible without causing tension and still
allowing movement.
The S-Cap-Air is now ready for operation.
14
S-Cap-Air
MSA
GB