Safety Hints - Endress+Hauser RIA250 Manual De Instrucciones

Safety hints

Correct use
- The display receives an analogue signal and shows the
corresponding value on the display. The analogue output
transmits the displayed value as either a current of voltage.
Two presettable limit values monitor the measured value for
any infingement of the preset conditions and control the two
output relays. Transmitters connected can be directly
powered by the unit.
- The manufacturer cannot be held responsible for damage
caused by incorrect use of the instrument. Changes must not
be made to the unit.
- The unit has been designed for use in industrial areas and
must only be used in an installed condition.
- The process display is manufactured using state of the art
technology and complies to the IEC 61010-1 directives.
The unit could become dangerous if it is incorrectly installed or
used.
Therefore please take note of all the safety hints and
pictograms shown in these installation and operating
instructions. The meaning of the pictograms is as follows:
Hint: "Hint" means activities or sequences that, if not done
correctly could have an indirect influence on the
units operation or could release an unforeseen
unit reaction.
Attention: "Attention" means activities or sequences that, if not
done correctly could lead to personal injury or faulty
unit operation.
Warning: "Warning" means activities or sequences that, if not
done correctly could lead to serious personal injury,
to a safety risk or total damage to the unit.
Process display
41