Endress+Hauser RIA250 Manual De Instrucciones página 65

Parameter
* Display all
points
In order to simplify
operation and setting up
it is advisable to blend
out all linearization points
after they have been set
up.
The contents of the
points remains
unchanged and the
display can be switched
on again at any time.
The following addresses are only displayed when the
linearization points (
linearization points 1 to 32 are identical.
The entry sequence of the linearization points is random.
The sensor values (X-Value) are automatically sorted
upwards before they are saved.
Unused points, sensor value is identical "
automatically deleted and the number of points respectively
lowered in number.
If points are to be added later then the value under
must be increased to the required number. The new
addresses will be added before the last value. The remaining
linearization points should be entered in the new addresses.
This again is independent from sequence. The added values
will again be sorted upwards automatically before being saved.
Setting up selections
LSHOW
YES
All linearization points
are indicted in the
display
NO
The linearization
points are blended
out
LSHOW
) are active (
Default
settings
YES
YES
). Addresses for
-----
", are
COUNT
Process display
Actual
63