Endress+Hauser RIA250 Manual De Instrucciones página 63

Parameter
Numeric display
brightness
Increase or decrease 7
segment display
brightness
Bargraph brightness
Increase or decrease the
bargraph and set point
diode brightness
Programme name
Display address:
Display of the software
used in the unit.
Software version
Display address:
Display of the version
number of the software
used
Power frequency
Power supply frequency;
This is required in order
to eliminate any super-
imposed interferance of
the power supply
frequency on the signal
measurement.
Test
Test function for diverse
hardware components;
These are activated after
the component is
selected.
Once this address has been exited it is automatically reset to
Setting Up selections
BRNUM
Value:
0 to 9 (9 = max.)
BRLED
Value:
0 to 9 (9 = max.)
PNAME
SU-ID
FREQ
50 HZ
50 Hz power supply
60 HZ
60 Hz power supply
TEST
OFF
None
REL1
Relay 1 is energised
REL2
Relay 2 is energised
DISP
All segments on the
numberic display and
all LEDs are activated
for approx. 5 s.
Energised relay means
rest position, in fault alarm
and set point infringement
the relay is de-energised.
Process display
Default
Actual
settings
5
5
50 HZ
OFF
OFF
.
61