Operating Parameters - Endress+Hauser RIA250 Manual De Instrucciones

Process display
Operation of the switch time delay
Using this setting a time delay
SETP
If the measurement value falls below the preset switch
threshold
then the switch delay time counter is reset to zero. The time
counter restarts after a new infringement of the preset switch
threshold
This is also valid for minimum monitoring.

5.5 Operating parameters

Parameter
User code
User operation code.
An already set code can only
be changed if the old code is
first entered and the unit
setting up released. Then a
new code can be set.
* Set point code
Set point change requires
a release code entry
This address is only active when an operation code is set up.
60
Measurement value
SETP
DELY
À Relay de-energised
and activating the alarm indicator/relay can be installed.
SETP
(without hysteresis) within the time delay
SETP
.
Setting up selections
CODE
Value:
0000 to 9999
There is no operation
code active if "0" is set
LICOD
YES
Set points are code
protected
NO
Set points can be
changed without setting a
code
DELY
:
HYST
DELY
between switch threshold
Default
settings
0
YES
DELY
PARAM
Actual