Setting Up Using The Operating Matrix - Endress+Hauser RIA250 Manual De Instrucciones

Å
Identification field:
Additional information can be written onto the information
field. In order to write on this field follow these simple
instructions:
- Degrease and clean the front panel.
- Write on the field using a light and water resistant felt tip pen.

4.2 Setting up using the operating matrix

968,50
SAVE?
Ê
Press E push button for at least 3 seconds. Enter the
operating matrix.
Ë
Menü Select function group (selection using + or - push
button).
Ì
Selecting operation function.
Í
Parameter entry in editor mode
(enter/select data using + or - and acknowledge using E).
Î
Return from editor mode or operation function to a function
group. A return to the home position can be made by
simultaneous operation of the + / - push buttons a number of
times. Before returning a question is asked if the set up data
is to be saved.
Ï
Direct return to the home position
at least 3 seconds. Before returning a question is asked if
the set up data is to be saved.
Ð
Question whether data is to be saved (Selection YES/NO
with + or - push button and acknowledge with E).
.
Press E push button for
Process display
51