TOHATSU MFS 4C Manual Del Propietário página 57

5. Tighten the oil drain screw with apply-
ing oil on the sealing surface of screw.
(Use new oil drain washer)
Oil drain screw specified torque
18N·m (13 ft lb, 1.8 kgf
·
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn past
finger-tight. Have the oil filter adjusted to
the correct torque as soon as possible with
a torque-wrench.
6. Reset the engine in a vertical posi-
tion.
7. Repeat 3 to 7 procedures two or
three times to drain the oil com-
pletely.
8. Remove the top cowl and the oil filler
cap.
9. Fill the engine through filler port with
recommended oil (see chart below)
to the middle of dipstick mark.
10. Tighten the oil filler cap.
1
1. Oil filler cap (Dipstick)
m)
·
ENOF00446-0
INSPECTION AND MAINTENANCE
1
2
1. Upper limit (Max.)
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 12)
10W−40
10W−30
-30 -20 -10 0 10
-22 -4 14 32 50
Oil volume needed for complete oil replacement
450 mL (15.2 fl.oz.)
ENOW00925-0
CAUTION
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00031-0
Note
If any amount of water is found in
engine oil, making it milky white, consult
dealer.
If engine oil is contaminated with fuel,
emitting strong fuel smell, consult
dealer.
55
ENOF00447-0
20 30 40 ˚C
68 86 96 ˚F
ENOF00208-0
10